How To Open And Close Fireplace Flue

Open the flue damper for a fire. I was told the flue must be kept in the open position at all times.

The Chimney Box Own the original! backyard fireplace

That part seems to be right but the fireplace logs still shuts down and turns itself off and beeps until air is clear but i'm still scared.

How to open and close fireplace flue. The damper in your fireplace helps you control the flow of air when your fireplace is being used or not. How to operate a flue in a wood burning fireplace. The damper should be kept open until all embers are finished burning to prevent smoke from escaping into the home.

However, the opposite is true. When you have an active flame going, you want to leave the damper open so the smoke can escape through the flue. Using a flashlight, look inside your fireplace to locate a lever or set of pull chains, which may have rings on the ends.

If it is not marked, the typical style of the lever requires pushing it to open the flue or pulling it towards you to close it. Determine the position of the flue damper. Close it when it's not it use.

You lift the handle, push open the damper, and prop. Push the lever up slightly to disengage it from its support tab and then pull it away from the tab horizontally as the damper lowers into a closed position. Chimney top dampers sit at the top of the chimney with a chain and lever to open and close it.

If you can see up into the flue, the damper is open. Using a flashlight, poke your head inside the fireplace to look up into the chimney. These are typically found on the interior front wall of the fireplace.

The damper should always be fully open before lighting a fire and when the fireplace is in use. There is a pilot light which stays on and the tip if the flame stays yellow in color. If you leave the damper open, regardless of whether it is hot or cold outside, it will allow outside air to draft in and counter the effects of your heating and cooling system.

This duct within your chimney includes a damper that can be opened or closed by a lever or pull chains, in most instances. Once the flue is open, place. The device is typically marked to indicate proper positioning.

You turn the handle to a vertical position to open the flue damper and back to a horizontal position to close it. Locate the flue lever before starting a fire. The damper can be closed or open.

Either seal up the fireplace and never use it (they have magnetic covers which will work nicely) or climb in there (clean out fireplace first, but it will still be quite sooty) and figure out how to open/close the flue yourself. Yes, keep it open at all times. Carry out a visual check.

When the fireplace is not in use, the damper should always be closed. Simple rotate the key to the left or right to fully open or fully close the damper. To close it, you simply lift the handle up again, pull the damper shut, and set the handle back into position on the ratchet.

The damper should always be open when a fire is burning in the fireplace. Do all gas fireplaces have a flue? If your fireplace has pull chains, pull.

It might be an ornery old beast, but you should be. These dampers are open by lifting the handle up, pushing the damper upwards, and pinning the damper in the upward position by setting one of the notches on the handle onto the mounted ratchet on the frame of the fireplace. This is a movable plate that sits above the fireplace before the flue.

To remember whether your damper is open or closed (and to remember to close fireplace damper when the embers are completely cooled), you can use a brass damper hook with a closed and open side or a brass fireplace sign with a closed and open side. Close damper to save heat. A lever that’s pushed to the left will close the damper whereas a lever pushed to the right will open it.

To close a throat damper in a fireplace, lift the handle and pull it back towards you. You should be able to dampen the flue as you would with a wood fire to slow burn rate. The damper should always be fully open before lighting a fire and when the fireplace is in use.

You can experiment with just how open you want the damper to be, but it must be. If you pull the lever toward you, generally that will open most of the dampers. When you want to build a fire, open the flue damper first by pulling the chain or shifting the lever.

Check up into the chimney from your fireplace. If the flue is open, the smoke will go out of the chimney without any problem. If you're not sure which position is the open or shut, repeat step 2 to determine the position of the damper.

Other fireplaces use levers to operate the throat dampers by switching it to the right or left. Not all gas fireplace designs are the same. If a fire is lit and the damper is closed, the gas and debris have nowhere to go but into the house, causing a smoky situation.

Newer electric flue damper model designs allow you to open or close the flue with a simple push of a button. They even put a clip in the flue to keep it open to ensure it could never be completely closed. Some fireplaces have a lever while others will have pulley system consisting of two chains with rings on the end.

Similarly one may ask, is it ok to leave the flue open? I just had a wood burning fireplace turned into an artificial log gas fireplace. There will be a “key” style device in your fireplace wall.

But when you aren’t using your fireplace, leaving the damper open can allow warmth out and cold air in. Bring it down slowly and monitor for smoke intrusion. The thinking behind this theory is that, since warm air rises, any warm air in your home will travel up and out of the flue.

The flue is not open and i'm wandering if it should be. You can reach inside of the fireplace opening and behind the lintel to touch the damper. Close it when it's not it use.

Attached to the indoor fireplace end of the flue is a damper operated by a lever. Open the flue damper for. You should be able to open and close it with a knob (this is usually located on the front face of the fireplace) or rod (located in the fireplace, above the firebox).

If there's a lever, move it side to side or up and down to release it before sliding it horizontally. Pulling the handle towards you will close the damper. Start a small but smoky fire in your fireplace, say using papers or tinder alone.

If you have a throat damper, you can tell if it is closed if you see a barrier above your head. Operating the fireplace with the damper. When the damper is closed, it helps to keep heated air from going up the chimney.

The smoke when placed very close to the fireplace opening should rize up the flue. If the damper is closed, then the smoke will come out of the chimney and fill out the room. A pivot damper operates on a long, jointed handle.

Do keep a carbon monoxide detector in service as a safety precaution.

4 Ultimate Fireplace Safety Tips for Winter Safety tips